All In MedTech

Device Trial Radar · NCT07935902

Effect of Different Adhesive Removal Techniques After Orthodontic Bracket Debonding on Postoperative Hypersensitivity

Effect of Different Adhesive Removal Techniques After Orthodontic Bracket Debonding on Postoperative Hypersensitivity: A Randomized Clinical Trial

Last checked: Nov 20, 2026Latest source record: Nov 20, 2026 (this record)Source: ClinicalTrials.govMethods & limitations

Not yet recruiting

Status

Not yet recruiting

Enrollment

15

Planned (sponsor's estimate)

Start

Nov 2026

Primary completion

Jun 2027

Study completion Oct 2027

Sponsor

Lead sponsor
Asmaa Badr AbdelfatahAcademic, hospital or other
Sponsor type
Academic, hospital or other
First posted
Nov 13, 2026

More device trials from this sponsor

Design

Study type
Interventional
Phase
Not applicable (typical for device studies)
Allocation
Randomized
Model
Parallel
Masking
Double (participant, outcomes assessor)
Primary purpose
Treatment
FDA-regulated device
No
Who can join
All sexes, from 15 years, up to 30 years
Healthy volunteers
Yes

Summary

As written by the sponsor on the registry.

The objective of this randomized clinical trial is to evaluate and compare the effect of four different residual adhesive removal techniques following orthodontic bracket debonding on postoperative tooth hypersensitivity. The study compares low-speed tungsten carbide burs against fiberglass burs, white stone burs, and rubber-impregnated polishing points. Postoperative hypersensitivity will be evaluated using a Visual Analogue Scale (VAS) with an air-blast stimulus test immediately after debonding, at 24 hours, and at 7 days follow-up.

Conditions

  • Dentin Sensitivity
  • Orthodontic Adhesive Removal
  • Postoperative Hypersensitivity

Interventions

  • Low-Speed Tungsten Carbide BurDevice

    Composite resin is removed using a 12-fluted tapered low-speed tungsten carbide bur operated at 15,000-20,000 rpm under continuous air-water spray irrigation until all visible adhesive remnant is completely eliminated.

  • Fiberglass BurDevice

    Composite resin remnants are eliminated using a fiberglass resin-removal bur operated at 15,000-20,000 rpm under continuous air-water spray irrigation until all visible material is completely removed.

  • White Stone BurDevice

    Composite resin remnants are removed using a fine-grit Arkansas white stone bur (aluminum oxide) operated at 10,000-15,000 rpm under continuous air-water spray irrigation until the enamel surface is clear.

  • Rubber-Impregnated Polishing PointDevice

    Residual adhesive tags are removed and polished using a rubber-impregnated composite polishing point operated at 10,000-15,000 rpm under continuous air-water spray irrigation

Primary outcomes

What the sponsor says the trial is designed to measure.

  1. Postoperative HypersensitivityTime frame: Baseline (immediately post-debonding, before clean-up), 24 hours, and 7 days post-adhesive removal.

Locations

1 site in 1 country. Site status is shown where the registry gives one.

  • Faculty of Dentistry, Cairo University

    Cairo, Egypt

Contact details for sites and study staff are not shown here. To ask about taking part, use the contact information on the registry record.

For information only. Nothing on this page is investment, legal, tax or medical advice, and nothing here is an offer to sell or a solicitation of an offer to buy any security. The data comes from public government sources, which can be incomplete, delayed or wrong. Check the original record before relying on it.